If your washer dryer is not entering the spin cycle, spinning slowly, stopping before spin, or leaving clothes soaking wet, the problem may be linked to drainage, the motor, belt, door lock, pump, load balance system or electronic control board.
- Spin Cycle Fault
- Soaking Wet Clothes
- London Repair Service
When the appliance cannot reach the correct spin speed, excess water stays trapped inside the fabric. As a result, clothes may feel heavy, wet and difficult to dry even when the programme appears to have completed.
To diagnose the issue properly, the drainage path, filter, pump, belt, motor, pressure sensor, door lock and control board may need to be checked.
Common Reasons Your Washer Dryer Is Not Spinning
Drainage Problem
If water remains inside the appliance, the washer dryer may refuse to enter the spin cycle or reduce spin speed.
Unbalanced Load
Heavy towels, bedding or unevenly distributed laundry can cause the machine to slow down or cancel the spin cycle.
Worn or Broken Belt
A loose, worn or broken belt can stop the drum from turning correctly or reaching the correct spin speed.
Motor Issue
If the motor is weak or not receiving the correct signal, the appliance may not be able to spin the drum properly.
Door Lock Fault
If the machine cannot confirm the door is safely locked, it may refuse to enter the spin cycle for safety reasons.
Control Board Fault
The control board may fail to send the correct signal to the motor, pump or spin programme, causing spin failure.
When to Book a Repair
When Should the Appliance Be Checked?
If the spin fault happened only once, the load may have been unbalanced. But if the problem repeats, clothes stay wet, or the drum does not turn at all, the appliance should be inspected by a technician.
Clothes stay soaking wet
This means excess water has not been extracted from the laundry.
The drum does not move
The belt, motor or control board may need checking.
The machine stops before spin
This may be connected to drainage, the door lock or load balance detection.
Washer Dryer Not Spinning FAQs
The fault may be caused by drainage issues, load balance problems, belt wear, motor faults, a door lock issue, pump problems or the control board.
The machine may not have reached the correct spin speed, or it may not have drained fully before the spin stage.
Yes. If the load is too heavy or uneven, the appliance may reduce or stop spinning to protect itself.
This can be linked to the belt, motor, pump or electronic control system, so the appliance should be checked.
Is Your Washer Dryer Not Spinning?
If your washer dryer is not completing the spin cycle or leaving clothes wet and heavy, book a repair request and arrange a fault inspection in London.